Is 9/32 A Good Tire Tread Depth?

What is a good tire tread depth?

Good tire tread depth will be 6/32 or deeper.

If the depth is 4/32, you should start thinking of replacing your tires and getting new ones.

2/32 or less means that you should change your tires ASAP..

Is 9/32 A good tire tread depth?

Average new tires used on cars typically start with 10/32″ to 11/32″ of original tread depth. … As mentioned above, tires are legally “worn out” In most States when they reach 2/32″ of remaining tread depth. For example, a typical tire that starts with 10/32″ of original tread depth has only 8/32″ of useable tread depth.

Should I replace my tires at 4 32?

The Tire Rack’s advice is that if rain and wet roads are a concern, you should consider replacing your tires when they reach approximately 4/32″ of remaining tread depth. Since water can’t be compressed, you need enough tread depth to allow the rain to escape through the tire’s grooves.

What tread depth is illegal?

Tread Depth – Why Too Little is Never Enough | Tire Rack … 1.6mm) of remaining tread depth. U.S. law requires tires to have easy-to-see Tread Wear Indicator bars running from one side of their tread design to the other when the tire’s tread has worn down to the minimum legal limit of 2/32 inch.

What percentage of tread is 7 32?

If the tread depth is 8/32″, it has 75 percent remaining. If the tread depth is 7/32″, it has 62.5 percent remaining. If the tread depth is 6/32″, it has 50 percent remaining. If the tread depth is 5/32″, it has 37.5 percent remaining.

How far can you drive on 4/32 tread?

Therefore you should get to 28,400 miles before your tires get down to 2/32″. This also implies that your tires had ~4/32″ depth 5,000 miles ago. Regardless of the remaining tread depth, I recommend that you have the tires replaced before the rainy season starts there.

roughly 1.6mmThe law requires car tyres to have a minimum tread depth of 1.6mm in a continuous band around the central three quarters of the tyre. To help you judge how much tread you have on your car tyres, manufacturers often mould tread bars at roughly 1.6mm.

Is 7 32 A good tire tread depth?

If your gauge measurement reads: 6/32″ or higher: Your tire’s tread depth is sufficient. 5/32″: If snow-covered roads are a concern, you should consider replacing your tires. 4/32″: If you frequently drive on wet roads, consider replacing your tires.

What is 9 32 tread left?

9/32″ = .28125″ (7.144 mm) and so on. The smaller the value, the shallower the grooves, the closer the. tire is to being worn out. A tool known as a Tread Depth Indicator is convenient for taking.

What does 3/32 tire tread mean?

If your tread is at 3/32 inch, your tires are nearly worn out, and you should start shopping. At 2/32 inch, you have legally bald tires, and you need to replace them immediately. You can also check tread wear by looking at your tire’s indicator bars.

How many 32 is a new tire?

New tires typically come with 10/32” or 11/32” tread depths, and some truck, SUV and winter tires may have deeper tread depths than other models. The U.S. Department of Transportation recommends replacing tires when they reach 2/32”, and many states legally require tires to be replaced at this depth.

How long does it take to wear 1/32 of a tire?

Depending on the tread compound, the tread will wear down about 1/32 inch for every 5,000 to 8,500 miles of normal driving. Consequently, a new set of tires may last 40,000 to 70,000 miles on average.